濟南變速箱維修告訴變速箱機電故障時應注意什么?只需要拆下電腦變速箱和電磁閥就可以進行維修，為大家更詳細更快的了解這個變速箱我們的維修人員總結了一些變速箱的維修案例。下面開始拆卸和修理變速箱電腦。

　　Jinan gearbox maintenance tells us what should be paid attention to when the mechanical and electrical failure of gearbox? Just remove the computer gearbox and solenoid valve to carry out maintenance, for you to understand this gearbox more detailed and faster, our maintenance staff summarized some cases of gearbox maintenance. Next, start disassembling and repairing the gearbox computer.

　　濟南變速箱維修

　　Maintenance of Jinan Gearbox

　　拆下油螺絲，拆下變速箱中的油，再拆下變速箱油底殼，檢查并修復損壞點。

　　Remove the oil screw, remove the oil in the gearbox, remove the oil pan of the gearbox, check and repair the damage point.

　　減速箱油底殼放下，放下油底殼，注意減速箱內部是否有殘余油，確保油已放掉，即可拆卸電腦和閥體。

　　Put down the oil pan of the reducer, put down the oil pan, pay attention to whether there is residual oil in the reducer, ensure that the oil has been released, you can remove the computer and valve body.

　　發現變速箱內部不能穿粉的過濾器來過濾掉灰塵及時,這也是變速箱機電單位,真正的原因損壞由于變速箱機電傳動單元內工作環境要求非常高,在圖中傳播引起的失敗保持油潤滑不滿足標準,這將加速磨損的傳播,并縮短使用壽命。

　　It is found that the dust can not be filtered through the powder filter inside the gearbox in time. This is also the mechanical and electrical unit of the gearbox. The real reason for the damage is that the working environment of the mechanical and electrical transmission unit of the gearbox is very demanding. The failure caused by the transmission in the figure keeps the oil lubrication unsatisfactory, which will accelerate the transmission of wear and shorten the service life.

　　濟南變速箱維修

　　Maintenance of Jinan Gearbox

　　拆下電腦變速箱和閥體，由于電磁閥不能正常工作，導致變速箱停止和鎖緊現象，維修人員發現故障后檢測，是由于壓力控制電磁閥3位停滯造成的。(在此提醒大家，電腦變速箱出現故障，在損壞不嚴重的情況下，一般可以進行修復)。如果電磁閥出現故障，必須更換新的電磁閥。還有閥體，閥體輕微的油污堵塞可以通過清洗修復，但磨損的閥體無法修復，只能更換新的閥體才能解決這個問題。

　　Remove the computer gearbox and valve body, because the solenoid valve can not work properly, leading to the transmission stop and lock phenomenon, maintenance personnel found fault detection, is caused by the pressure control solenoid valve 3-position stagnation. (I would like to remind you that if the computer gearbox fails, it can generally be repaired if the damage is not serious). If the solenoid valve fails, a new solenoid valve must be replaced. There is also the valve body, the slight oil blockage can be repaired by cleaning, but the worn body can not be repaired, only to replace the new body to solve this problem.

　　該電磁閥已被損壞更換，故障排除，由此可見，變速箱故障時，及時檢查和維修，不會避免另外兩種內部損壞造成的損失。

　　The solenoid valve has been damaged and replaced. Troubleshooting shows that when the gearbox fails, timely inspection and maintenance will not avoid the loss caused by the other two internal damages.

　　以上是濟南變速箱維修為大家整理的相關內容，想要了解更多內容，歡迎訪問網站：http://www.gxrbbs.com

　　These are the related contents of Jinan gearbox maintenance for you. For more information, please visit the website: http://www.gxrbbs.com.